Electric Installation – operating the Electric in to the Cabinet Print
This instructional guide will assist in the planning/installation associated with Electrical Power Supply for the Acrylic Spas.
Most of our acrylic tubs have detachable case panels which cover the whole border regarding the bath tub.
Whenever operating the electric through the spa, the access point to the case doesn’t need become put appropriate during the Control Pack location. Our spas usually do not come built with a pre-drilled opening for electric so access are through any of the cabinet panels.*
*NOTE: We usually do not advise setting up the electric by way of a case panel that is based in front a Pump, Control Pack, Blower, or Gate Valve. These panels will probably should be eliminated at some point for maintenance or servicing.
Selecting a place
Whenever choosing the best place to go into the case, do this on the basis of the following:
- security (don’t create tripping hazards)
- access points for users to enter the bath tub
- action positioning
- cover opening position (bottom mount lifters need the address remainder low next to the case)
- cover lifter mounts
Producing an Access Point
A Spade Bit is not recommended since there are no pre-drilled holes, access through the panel is done using a Hole Saw for a clean cut. The best location to put a gap when it comes to cord, could be less than six ins up through the base for the cabinet panel, and 3 to 4 ins in through the outside side of the case panel. Take note that the case panels have actually lumber framework and insulating foam inserts.